Product#: K521

1949-82 GM; Accelerator Rod Grommet and Sleeve Set ; Various Models

OER® reproduction of the original accelerator rod grommet and sleeve unit where the accelerator rod fits into the linkage. This grommet often deteriorates due to engine heat or chemical spillage. Replacing the grommet will...


Product#: UK915

Universal Fuel Tank Anti Squeak Rubber Set; Various Models: 36" Long

This universal anti-squeak insulator set includes two rubber strips that insert in between the gas tank and the mounting straps to eliminate any noise from tank movement and vibration which may occur. One foam rubber pad...


Product#: AL124

Accelerator Throttle Rod; Universal Fit

Universal style accelerator throttle rod for various GM, Ford, Chrysler, Dodge, Plymouth models. This accelerator rod is for use when modifications will not allow the use of the original rod between the accelerator pedal...


Product#: TF700017

1955-57 Chevrolet; Fuel Tank Sending Unit; For 9 Passenger Wagon; 5/16" Line

Reproduction fuel sender for your classic Chevy 9-passenger wagon. Each sender is produced in quality steel to resist corrosion within your fuel tank. Provides the fuel gauge with the signal to indicate fuel level. Comes with...


Product#: TF700018

1955-57 Chevrolet Wagon & Nomad; Fuel Tank Sending Unit; 3/8" Line

Reproduction fuel sender for your classic Chevy wagon or Nomad. Each sender is produced in quality steel to resist corrosion within your fuel tank. Provides the fuel gauge with the signal to indicate fuel level. Comes with...


Product#: TF700294

1957 Chevy Bel Air, 150, 210; Fuel Door Inner Support Box ; Inside Quarter Panel

Reproduction fuel box door for 1957 Chevrolet models. This reproduction is installed in the quarter panel where the gas fuel door is located. Manufactured in stamped steel to original specifications. Includes the fuel door...


Product#: C67808

1959-1988 GM; Universal Fuel Tank Anti Squeak Rubber Set; Various Models: 39" Long; For 1" Wide Straps

Universal style anti squeak cushions are designed to install between the gas tank and the gas tank straps. These fuel tank anti squeek pads cushion the gas tank from the body and straps to reduce noise caused by metal to...


Product#: CX5042

1954-59 Chevy, GMC Truck; Fuel Tank Sending Unit; Universal Fit; without Pick-Up Tube; 0-90 Ohm

Universal fuel tank sending unit for various GM and other models that require a 90 ohm sender. Designed for use with OE or aftermarket 0-90 ohm gauges, each sending unit includes the sender, float, float rod, hardware,...


Product#: 153665B

Throttle Cable 36"" Cut-To-Fit; Stainless Steel; Black

This throttle cable is designed with a specially extruded liner to extend the life of the cable. Cables are equipped with aluminum fittings and aluminum ferrule to eliminate fraying. Clevis is designed to eliminate cotter...


Product#: 9047E

Fuel Filler Hose; Nitrile 70 Shore Rubber; 2" ID x 15" Length

Reproduction fuel filler hose to connect fuel neck to fuel tank on a variety of models requiring a 2" ID fuel hose. This hose can be used as is, or if you require a shorter piece, you can cut this 15" fuel hose to your...


Product#: 153665A

1946-02 GM; Various Models; Throttle Cable; 36""; Stainless Steel ; Cut-To-Fit

This throttle cable is designed with a specially extruded liner to extend the life of the cable. Cables are equipped with aluminum fittings and aluminum ferrule to eliminate fraying. Clevis is designed to eliminate cotter...


Fuel Filler Hose; Nitrile 70 Shore Rubber; 2" ID x 20" Length
NEW

Product#: 9047G

Fuel Filler Hose; Nitrile 70 Shore Rubber; 2" ID x 20" Length

Reproduction fuel filler hose to connect fuel neck to fuel tank on a variety of models requiring a 2" ID fuel hose. This hose can be used as is, or if you require a shorter piece, you can cut this 20" fuel hose to your...


Product#: TF700038

1956-62 GM; Fuel Tank Filler Hose; 2" ID x 4-7/16" Length

Reproduction fuel tank filler hose for 1957 models. Hose is specifically engineered to stand up to gasoline, fuel oil, and other petroleum-based products. Clamps sold seperately. Measures 4-7/16" in length, inside diameter...


Product#: TF700512

Spring Steel Rod Clip, Fits 1/4" Rod Diameter, RH, 17/64" ID.

Correct style rod clip used on various GM vehicles. Fits 1/4" rod diameter, RH, 17/64" ID. These reproduction transmission linkage rod clips need to be replaced when replacing your linkage rods. 1955-57 Chevrolet...


Product#: 14048

1958-88 Holley Carburetor Fuel Bowl Screw; 2-1/2"

Reproduction 2-1/2" flat blade carburetor fuel bowl screw for Holley carburetors. This special screw is specifically designed in the correct original configuration and head design for the early model Holley carburetors. Many...


Product#: K915

Universal Fuel Tank Anti Squeak Rubber Set; Various Models: 24" Long; For 1" Wide Straps

Reproduction fuel tank anti squeek set for vehicle models. Includes one 5-1/4" x 2" x 1/2" precision die cut neoprene tank to floor cushion, two 24" x 1-1/4" molded rubber strap to tank cushions, and two 24" x 2 " x .060"...


Product#: T76063

Billet Aluminum; Fuel Filler Neck; with Pop-Up Gas Cap

Billet aluminum flush mount fuel filler neck with pop-up gas cap is the perfect addition to your classic car or truck when adding a non-stock fuel filler location or relocating your fuel tank. Features a super sanitary and...


Product#: 62531

Electric Fuel Pump; with Cadmium Plated Housing; 100 GPH - 7 PSI

This externally-mounted electric fuel pump is ideal for most street and strip applications. Proven rotary vein technology provides high flow and stable pressures with minimal vibration and sound. Each pump features 3/8"...


Product#: 62561

Electric Fuel Pump; with Cadmium Plated Housing; 140 GPH - 9 PSI

This externally-mounted electric fuel pump is ideal for most street and strip applications. Proven rotary vein technology provides high flow and stable pressures with minimal vibration and sound. Each pump features 3/8"...


Product#: TF700299

1957 Chevrolet Bel Air, 150, 210, Del Ray; Upper Fuel Tank Filler Neck; Zinc Coated; Except Station Wagon, Nomad Models

A reproduction of the original upper fuel tank filler neck designed for use with 1957 Chevrolet Bel Air, 150, 210, and Del Ray, 2 & 4 door convertible, hardtop, and sedan models. Each filler neck is manufactured in quality...