Product#: ST016

1955-72 Buick, Chevy, Pontiac, Oldsmobile, Full Size; Convertible Top Hydraulic Pump Seal Set

Hydraulic pump seal set designed for use with the various 1955-72 GM Full Size convertible models listed. This set contains 2 large O-rings. Depending on the year of your car, only 1 may be required. These large O-rings seal...


Product#: 14914

1955-72 Camaro, Firebird, Impala, Nova; Convertible Top Hose Retainer; Push In Style

Reproduction of the original hose retainer clip designed for use with 1967-69 GM convertible models. Each clip is manufactured in stamped steel and heat treated for extra strength. This clip is designed to retain the...


Product#: 153078

1967-69 Camaro, Firebird; Convertible Top Boot Interior Snaps with Screws; 4 Piece Set

Reproduction convertible top boot snap and screw set for 1967-69 Camaro and Firebird models and any other vehicle that requires a screw-on style snap. These snaps are used to secure the convertible top to the inner rear...


Product#: HK260

1958 Chevrolet Impala, Pontiac Bonneville, Chieftain; Convertible Top Cylinder; Various Models; Each; Made in the USA!

Reproduction of the original convertible top cylinder designed for use with 1958 Impala, Bonneville, Chieftain convertible models. All convertible top cylinders are not the same. This convertible top cylinder is manufactured...


Product#: HK220

1955-61 Bel Air, Impala, Electra; Convertible Top Hydraulic Hose Set; Black Rubber; Various Models

Reproduction of the original style hydraulic hose set designed to fit a wide variety of 1955-61 Buick, Chevrolet, Cadillac, Oldsmobile, and Pontiac convertible models as listed below. Finding original style hose sets for your...


Product#: CBK402

1958 Impala Convertible Top Bolt Set

This nickel plated hardware set allows you to replace every bolt, screw, nut, bushing, grommet, etc., in your original convertible top frame. Each set contains detailed instructions, separately bagged and labeled parts for...


Product#: UCR001

1955-64 Bel Air/Impala; Bolt Set; For Convertible Top Upper Cylinder Rod; 8-Piece Set

This is reproduction of the factory convertible top upper cylinder rod bolt set for 1955-57 Bel Air and 1958-64 Impala convertible models. Each 8-piece set includes (2) bolts, (2) nylon bushings, (2) wavy washers, and (2)...


Product#: CRP400

1958-64 Impala Convertible 24 Piece Pinch Rail Pad Set

Don't try to re-use old, compressed and hardened originals, these pads will make your top replacement more complete and better fitting. Mounts in trunk between the rear pinch rail and the body.


Product#: 3698109

1951-75 Convertible Power Top Motor Mounting Grommet - Each

Reproduction of the original rubber mounting / insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a...