Product#: HK262

1961 Impala, Eldorado, Electra, LeSabre, Bonneville, Catalina; Convertible Top Cylinder; Each; Made in the USA

Reproduction of the original convertible top cylinder designed for use with 1961 Buick, Cadillac, Chevrolet, Pontiac, and Oldsmobile full size convertible models. All convertible top cylinders are not the same. This...

Product#: 14914

1955-72 Camaro, Firebird, Impala, Nova; Convertible Top Hose Retainer; Push In Style

Reproduction of the original hose retainer clip designed for use with 1967-69 GM convertible models. Each clip is manufactured in stamped steel and heat treated for extra strength. This clip is designed to retain the...

Product#: 153078

1967-69 Camaro, Firebird; Convertible Top Boot Interior Snaps with Screws; 4 Piece Set

Reproduction convertible top boot snap and screw set for 1967-69 Camaro and Firebird models and any other vehicle that requires a screw-on style snap. These snaps are used to secure the convertible top to the inner rear...

Product#: ST016

1955-72 Buick, Chevy, Pontiac, Oldsmobile, Full Size; Convertible Top Hydraulic Pump Seal Set

Hydraulic pump seal set designed for use with the various 1955-72 GM Full Size convertible models listed. This set contains 2 large O-rings. Depending on the year of your car, only 1 may be required. These large O-rings seal...

Product#: HK237

1955-62 Buick, Cadillac, Chevrolet, Pontiac, Oldsmobile; Convertible Top Motor And Pump Assembly; Various Models

Reproduction convertible top motor & pump assembly made to provide consistent hydraulic pressure and dependability. Raise and lower the power top with ease by replacing the old or worn out original. The motor comes complete...

Product#: HK220

1955-61 Bel Air, Impala, Electra; Convertible Top Hydraulic Hose Set; Black Rubber; Various Models

Reproduction of the original style hydraulic hose set designed to fit a wide variety of 1955-61 Buick, Chevrolet, Cadillac, Oldsmobile, and Pontiac convertible models as listed below. Finding original style hose sets for your...

Product#: L21002P

1961-64 Impala; Convertible Top Pump/Motor Cover Shield

Replacement convertible top motor cover shield for 1961-64 Impala convertible models. This replacement cover is manufactured from a high quality stamped steel to factory specifications. {specs} {fitment}

Product#: RD7004

1961-62 GM B-Body Full Size; Convertible Top Cylinder to Floor Brackets; Pair

Reproduction top cylinder to floor brackets for 1961-62 GM full size B-Body convertible models. Each bracket is manufactured in stamped steel to factory specifications. Will replace the old or missing brackets exactly. Sold...

Product#: CRP400

1958-64 Impala Convertible 24 Piece Pinch Rail Pad Set

Don't try to re-use old, compressed and hardened originals, these pads will make your top replacement more complete and better fitting. Mounts in trunk between the rear pinch rail and the body.

Product#: 7614749

1949-75 GM, Dodge, Plymouth; Convertible Top Rear Window Binding End Clip, with Screw

OER reproduction of the original convertible top rear binding end clip that was used for most 1949-75 GM, Dodge, and Plymouth convertible models. This stainless steel end clip covers covers and finishes both ends of the rear...

Product#: 3698109

1951-75 Convertible Power Top Motor Mounting Grommet - Each

Reproduction of the original rubber mounting / insulation grommet used on various GM vehicles with the optional power top. These rubber grommets install on the pump assembly and secure it to the vehicle while creating a...

Product#: CM2148A

1961-64 Impala, Nova, Electra, Wildcat; Convertible Convertible Chrome Top Latch Screw; Each

Reproduction of the convertible latch screws designed for use with 1961-64 GM convertible models as listed below. Each phillips head screw is manufactured to correct specifications featuring a chrome finish matching the...