and Performance Parts and Accessories
1961 Chevrolet Impala - Engine Components - Results for 409
See results below for 1961 Chevrolet Impala - Engine Components - "409". Classic Industries is America's first choice for GM and Mopar Restoration parts and accessories.
We now offer a quality reproduction of the deep groove crankshaft pulley for 1959-61 Hi-Po 348 and 1961-65 409 cubic inch passenger car models. This pulley is identical to the original GM including the early original part #3766987 correctly s tamped in the front surface. Made in USA Important Warning Concerning Crankshaft Pulleys. Stock r eplacement, aftermarket stamped steel or cast iron pulleys are not designed to exceed 400 horsepower or 6000 RPM. Using reproduction pulleys on engines in excess of these limits may result in catastophic disintegration of the pulley causing seve re damage to the engine, cooling system and body parts. Classic Industries® assumes no liability for damages caused by improper usage of pulleys. Please besure to install the pulley properly to avoid damages that could occur from impr oper installation or exceeding the recommended RPM limitations. Fits: 1959-61 348 Hi-Po 1961-65 409
Looking for the high tech race look for your Chevy 409 cubic inch V-8. Consider this March Performance serpentine conversion. The one piece alternator and air conditioning bracket provides a rigid support for the alternator and A/C compressor . Four separate idlers guarantee the ultimate in belt to pulley contact area for sure "no slip" operation. This Style Track sets makes use of a unique easy to use belt tension adjustment tool. Once the belt tension has been set, the adjustment tool is easily removed and stowed away until the next time the belt requires adjustment. As a result, the Style Track displays a much cleaner appearance. Set includes: 105 amp polished alternator Alternator pulley with fa n and nose cover Matching polished A/C compressor A/C compressor nose cover Edelbrock water pump and hardcoated pulley Alternator and A/C Bracket Crank pulley (larger diameter for better accessory drive) 4 Idlers for better belt wrap Belt tensioning tool Mounting hardware Made in the USA Uses a 66" belt Part # SB660 (so ld separately). Note: Shipped overweight. No further discounts apply.