Product#: 3415

Bumper Bolt with Conical Keps Hex Nut; Polished Stainless Steel Capped Head; 3/4" Diameter; 3/8-16" x 1"; Zinc Plated

Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...


Product#: 2710

Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head

Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...


Product#: 8610

Flat Washer; 1/2" USS; Zinc Plated

1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...


Product#: 13757

1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon

Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...


Product#: MD2128

1956-64 Chrysler, Dodge, Plymouth; Convertible Top Motor and Pump Assembly

This OE style replacement motor and pump assembly features original style locations for electric and fluid connections. Fits a wide variety of 1956-64 Chrysler, Dodge, Plymouth, Imperial, and Desoto models including, but not...


Product#: DW657T

1965-68 Mopar C-Body; Windshield; Tinted With Blue/Green Shade

OER reproduction windshield glass for various Chrysler, Plymouth and Dodge full-size passenger car models, based on the C-Body platform. Replacing your original damaged or missing windshield glass will enhance your vehicle?s...


Product#: MD2198

1966-70 Chrysler, Plymouth, Dodge A, B, C-Body; Convertible Top Hydraulic Cylinder; Each

Reproduction of the original convertible top cylinder designed for use with 1966-70 Chrysler, Dodge and Plymouth A, B, and C Body convertible models as listed. All convertible top cylinders are not the same. This convertible...


Product#: 10362

Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate

OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10...


Product#: 3899508

1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each

Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...


Product#: HK234

1960-72 GM, Chrysler, Ford; Convertible Top Hydraulic Hose Set; with Power Top; White Hose; O.L.114"; Center to End 57-1/4"

Reproduction of the original hydraulic hose set designed for use with a wide variety of convertible models as listed. Finding an original hose for your early convertible is next to impossible. If you own a convertible model...


Product#: K51020

1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Storage Bag

Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot storage bag. The storage bag will help protect your vehicles top boot while being stored in the...


Product#: 11503957

U-Nut; M6 - 1.0; Panel Range .030" to .160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from .80mm to 4 mm. (.030" to .160") Specifications: OE #: 11503957 Quantity: Individual...


Product#: A1017

3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each

Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...


Product#: ME7602

Wiper Blade Insert; Replacement; 16" Anco Style; Each

OER reproduction Anco-style windshield wiper blade insert for various classic American vehicle models from the 1960's and up. These 16" wiper blades are manufactured from quality molded rubber as original. Refill is...


Product#: MP40101

1965-74 Chrysler, Dodge, Plymouth; Windshield Washer Pump; Replacement

Replacement style windshield washer pump assembly designed for use with the applications listed below. The windshield washer pump circulates water from the windshield washer jar to the washer nozzles. This is a replacement...


 3/8"-16X 15/16"; Bumper Bolt; Stainless Steel Cap; Flat Head; Package of 25
NEW

Product#: TR17758B

3/8"-16X 15/16"; Bumper Bolt; Stainless Steel Cap; Flat Head; Package of 25

Package of 25 reproduction bumper bolts that measure 7/16-14 x 1-1/2" with a stainless steel cap and round head. Willl fit a wide variety of vehicles including 1957-72 Ford F-Series Truck and many other Ford Motor Company...


Product#: 17528D

16" Windshield Wiper Blade Refill; Pair

Reproduction of the windshield wiper blade inserts for various models equipped with 16" wiper blades. Each blade insert is manufactured for perfect fit, function and appearance when used with the proper blade assembly....


Product#: *881358

1960-70 Ford, 1973-84 GM Truck; 16" Trico Style Wiper Blade Assemblies; Pair; Rainbow Type; 1/4" Bayonet Connector; Matt Stainless

Reproduction of the original Trico Style wiper blade refill designed for use on the various models that require a 16" Trico style rainbow type wiper blade. Each wiper blade assembly will replace the original and offer years...


Product#: 17529B

1960-84 Windshield Wiper Blade; 16" Trico; Rainbow Type; 1/4" Bayonet Connector; Matt Stainless

Reproduction of the original Trico Rainbow Type wiper blade designed for various models originally equipped with Trico blades. Each wiper blade will replace the original and offer years of service. Each blade comes complete...


Product#: *C15315

U-Nut Set; M6 - 1.0; Panel Range .030" to .160"; Black Phosphate; 25 Piece Set

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from .80mm to 4 mm. (.030" to .160"). Set of 25 u-nuts. Specifications: OE #: 11503957 ...