Product#: 3415

Bumper Bolt with Conical Keps Hex Nut; Polished Stainless Steel Capped Head; 3/4" Diameter; 3/8-16" x 1"; Zinc Plated

Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...

Product#: 2710

Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head

Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...

Product#: 8610

Flat Washer; 1/2" USS; Zinc Plated

1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...

Product#: 13757

1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon

Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...

Product#: 548935

1962-1977 GM; Windshield Washer Jar Bracket; Various Models

OER® replacement of the original windshield washer jat bracket designed for use on various 1962-77 GM models as listed. This bracket is manufactured in stamped steel and features an EDP coating for rust resistance. This...

Product#: 3764424

1962-72 Chevrolet/Pontiac; OE Style Firewall Pad Fastener; Plastic; 7/16" X 1.50"; Various Models

Correct reproduction plastic firewall pad fastener for various GM models including 1967-69 Camaro, 1967-69 Firebird, 1962-72 Nova and 1962-69 Impala models. These fasteners are required to allow the firewall pad to attach...

Product#: 10362

Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate

OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...

Product#: 3899508

1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each

Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...

Product#: BG3099Y

1961-62 Impala / Fullsize 4 Door Hardtop Smoke Back Glass

Replacing your original damaged or missing back glass will enhance your vehicle's appearance and safety by allowing you to see clearly. Don't settle for anything less than original quality glass when replacing the windows of...

Product#: FW607C

1961-62 GM Full Size Passenger Car Windshield; Bubble Top; Clear

OER reproduction glass for a variety of 1961-62 GM full-size passenger car sedan, hardtop, wagon (Bubble Top) models. Features clear laminated glass and no date coding. Each windshield is professionally packed with extra care...

Product#: BG3130Y

1962-64 Impala, Bel Air, Biscayne 2 & 4-Door Sedan; Rear Window Glass; Custom Gray Tinted

Reproduction back window glass for various 1962-64 Buick, Chevy, Oldsmobile, and Pontiac Full Size 2 and 4 door sedan models except bubble top. Each rear window glass is manufactured in tempered glass to factory...

Product#: K51020

1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Storage Bag

Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot storage bag. The storage bag will help protect your vehicles top boot while being stored in the...

Product#: 3819074

1958-80 TRICO RF-15 Style Wiper Blade Refill; 15" Length; Reproduction; Various Models

OER® reproduction of the original Trico RF-15 wiper blade insert/refill for 15" TRICO wiper blades. This period-correct TRICO RF-15 style insert is made with a stainless steel vertebra and a precision wiping edge produced...

Product#: 4753019

1959-72 Buick; Chevrolet; Oldsmobile; Pontiac; Trunk Lock Latch Assembly; Manual; Various GM Models

This OER® reproduction of the original manual trunk lid latch assembly. This correct reproduction installs in the trunk area and is connected to the trunk lock cylinder by the handle shaft. Allows the trunk lid to lock...

Product#: BG3098C

1961-62 Impala, Bel Air; Rear Window Glass; Clear; 2-Door, Bubble Top; OER

Reproduction back window glass for various 1961-62 Buick, Chevy, Oldsmobile, and Pontiac 2 door bubble top models. Each rear window glass is manufactured to factory specifications featuring correct glass shape and contours...

Product#: 11503957

U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...

Product#: C2377

1961-62, 1965-68 Impala, Bel Air, Biscayne, Caprice; Front Outer Door Handle Set; 2 or 4 Door

Quality reproduction outer door handle set for 1961-62 and 1965-68 Impala and Full Size models. Each door handle set is manufactured in zinc die-cast zinc and includes a high quality triple chrome plating offering a factory...

Product#: A1017

3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each

Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...

Product#: K164

Windshield Wiper Blades; Aero Style; 15"; for 1/4" (7mm) Bayonet Style Arms; Pair; Various Models

High quality reproduction of the stainless steel "Aero" Anti Wind-Lift Wiper Blades designed to fit 7mm wide bayonet style wiper arms. Popularized in the 1960's and 70's to combat wind lift at high speeds, these 15 inch wiper...

Product#: 152600A

1962-64 Impala, Full Size Hardtop, Sedan; Trunk Lid Hinges; LH & RH; EDP Finish

Reproduction trunk lid hinges for 1962-64 Chevrolet Impala, Bel Air, and Biscayne hardtop and sedan models. These hinges are manufactured in quality stamped steel to factory specifications and feature correct torque rod...