Product#: 3415

Bumper Bolt with Conical Keps Hex Nut; Polished Stainless Steel Capped Head; 3/4" Diameter; 3/8-16" x 1"; Zinc Plated

Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...


Product#: 2710

Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head

Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...


Product#: 8610

Flat Washer; 1/2" USS; Zinc Plated

1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...


Product#: 13757

1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon

Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...


Product#: 10362

Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate

OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...


Product#: 3899508

1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each

Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...


Product#: BG3163Y

1963-64 Impala 4 Door Hardtop Back Glass - Smoke

Replacing your original damaged or missing back glass will enhance your vehicle's appearance and safety by allowing you to see clearly. Don't settle for anything less than original quality glass when replacing the windows of...


Product#: BG3163C

1963-64 Impala 4 Door Hardtop Back Glass - Clear

Replacing your original damaged or missing back glass will enhance your vehicle's appearance and safety by allowing you to see clearly. Don't settle for anything less than original quality glass when replacing the windows of...


Product#: BG3168C

1963-64 Impala 4 Door Wagon Back Glass - Clear

Reproduction back window glass for 1963-64 GM B-body 4-door Station Wagon models. Replace your missing or damaged original back glass with our OEM quality reproduction glass. Each glass is professionally packed with extra...


1963-64 Impala, GM 4 Door Wagon; Back Window Glass; Custom Gray Tinted
NEW

Product#: BG3168Y

1963-64 Impala, GM 4 Door Wagon; Back Window Glass; Custom Gray Tinted

Reproduction of the original back window glass are now available for 1963-64 GM B-body 4-door Station Wagon models. Replace your missing or damaged original back glass with our OEM quality reproduction glass. Each glass is...


1962-64 Impala, Bel Air, Biscayne 2 & 4-Door Sedan; Rear Window Glass; Custom Gray Tinted
NEW

Product#: BG3130Y

1962-64 Impala, Bel Air, Biscayne 2 & 4-Door Sedan; Rear Window Glass; Custom Gray Tinted

Reproduction back window glass for various 1962-64 Buick, Chevy, Oldsmobile, and Pontiac Full Size 2 and 4 door sedan models except bubble top. Each rear window glass is manufactured in tempered glass to factory...


Product#: K51020

1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Storage Bag

Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot storage bag. The storage bag will help protect your vehicles top boot while being stored in the...


Product#: BG3129T

1962-64 Impala; LeSabre; Bonneville, Catalina 2 Door Hardtop Except Bubble Top; Rear Window Glass; Light Green Tinted

Reproduction back window glass for various 1962-64 Buick, Chevy, Oldsmobile, and Pontiac 2 door hardtop models except bubble top. Each rear window glass is manufactured to factory specifications featuring correct glass shape...


Product#: 4753019

1959-72 Buick; Chevrolet; Oldsmobile; Pontiac; Trunk Lock Latch Assembly; Manual; Various GM Models

This OER® reproduction of the original manual trunk lid latch assembly. This correct reproduction installs in the trunk area and is connected to the trunk lock cylinder by the handle shaft. Allows the trunk lid to lock...


Product#: 11503957

U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...


Product#: A1017

3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each

Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...


Product#: WB125

1955-72 Buick, Chevrolet, Oldsmobile, Pontiac; Kleerview Glass Washer Fluid Bottle; with Cap, and Mounting Bracket

Correctly reproduced glass windshield washer bottle that was common in various 1955-72 General Motors vehicles. Each bottle is manufactured in the correct factory configuration that replaces the old or missing original...


Product#: K231

1961-64 Impala, LeSabre, Wildcat, Catalina; Front Upper Door Hinge; 2/4 Door; LH or RH ; Each; Various Models

Reproduction of the original upper door hinge designed for use on 1961-64 Impala, Bel Air, Biscayne, and GM B-Body models. Sagging and worn door hinges can cause damage to doors, locks and hinge pillar sheet metal. Why go...


Product#: CM2022

1961-65 GM Full Size; Vent Window Regulator; Passenger Side; GM B Body Models

Reproduction of the original vent window requlator designed for use on various 1961-65 GM Buick, Chevrolet, Oldsmobile, and Pontiac full size models. Each regulator is designed and manufactured to replicate the original in...


Product#: 17528D

16" Windshield Wiper Blade Refill; Pair; 16" x 3/8" wide

Reproduction of the windshield wiper blade inserts for various models equipped with 16" wiper blades. Each blade insert is manufactured for perfect fit, function and appearance when used with the proper blade assembly....