Product#: 30203

Painless Remote Starter Solenoid Set

This set allows you to position the starter solenoid any place you need to in order to make maintenance easier, clean up an inner fender or just replace a factory starting circuit. Installation Instructions: Download Here...


Product#: 30201

Painless Hot Shot Plus Starter Solution; with Engine Bump Start Switch

The solution for vehicles with GM starters that are hard to start when hot, or vehicles with old or worn out electrical systems. Works by boosting available amperage to the starter solenoid. The Hot-Shot Plus model includes...


Product#: 30202

Painless Hot Shot Starter Solution; without Engine Bump Start Switch

The solution for vehicles with GM starters that are hard to start when hot, or vehicles with old or worn out electrical systems. Works by boosting available amperage to the starter solenoid. Installation Instructions:...


Product#: G0102

GM Starter Bolt 3/8"-16 X 1-7/8"

Genuine GM starter bolt for various models. Replaces OE # 14097279 - starter mounting bolt (short) 3/8-16 x 1.87" (or 3/8"-16 X 1-7/8"). Fits most (non gear reduction) small block & big block chevy starters. Sold...


1967-74 Dode, Plymouth; Mounting Bolt Set; 4-Piece Set; For Plastic Starter Shields
NEW

Product#: MP6538

1967-74 Dode, Plymouth; Mounting Bolt Set; 4-Piece Set; For Plastic Starter Shields

Starter shield mounting bolt set for plastic starter shields. Each set includes (4) 1/4"-20 x 3/4" Serrated head bolts to mount PLASTIC K Frame and Starter Splash Shields on all 1966-74 auto trans models equipped with the...


Product#: 14097278

Starter Bolt 3/8"-16 X 4-21/32"

Replacement starter bolt for models that require a 3/8"-16 x 4-21/32" bolt.


Product#: TT1002

Starter Heat Shield Set

In today?s high-heat environment, starters take in a lot of damaging heat that destroys the windings of the starter and solenoid. To combat this problem, we offer a non-conductive strap-on heat shield with a highly-reflective...

Starter Heat Shield Set

MSRP $30.99 set
Classic $27.99 set

Product#: MD2368

1964-74 Mopar Starter Mounting Hardware Set

Starter mounting hardware set for all 1964-74 Mopar models, excluding Hemi with Manual transmission. Each set includes studs, washers and all other hardware needed to mount the starter. Will not fit direct drive starter. ...


Product#: MD2366

1968-74 Mopar Starter Dust Shield

Replacement starter dust shield for 1968-74 Mopar models. Mounts between starter and bellhousing.


Product#: G0103

Starter Bolt; 3/8"-16 X 4.33"; For 4.3L 5.0L 5.7L, or 502 Engine

Genuine GM starter bolts for various models. For 4.3L 5.0L 5.7L, or 502 Engine. Replaces GM Numbers 12338064, 09000852, or 10465167. Works with GM Performance 9000852 or 12606096 high-torque mini starters, also works with...


Product#: MP6508

1967-72 Dodge, Plymouth A-Body; Starter / Transmission Linkage Splash Shield

Starter/transmission linkage splash shield for A-Body vehicles. Comes with 9 staples and a drill bit for installation. Original factory assembly line manual shows 9 staples to be used but we have seen anywhere from 5 to 7...