Product#: 3415

Bumper Bolt with Conical Keps Hex Nut; Polished Stainless Steel Capped Head; 3/4" Diameter; 3/8-16" x 1"; Zinc Plated

Reproduction GM bumper bolt for a variety of General Motors and Chrysler applications. Each zinc-plated steel carriage bolt features a polished stainless steel cap for superb cosmetic appearance, corrosion resistance and long...


Product#: 2710

Chrome Trim Screw, #8 x 3/4", With #8 Phillips Oval Head

Replacement chrome plated trim screws used on various GM vehicles. Correct hardware can make any installation job easier. Replace your missing or damaged hardware with these quality reproductions. This part is original...


Product#: 8610

Flat Washer; 1/2" USS; Zinc Plated

1/2" USS zinc plated Flat Washer for a variety of applications. A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such...


Product#: 13757

1965-69 Impala, Camaro, Bel Air, Firebird; Hood Insulation Fastener; Black Nylon

Replacement black nylon 2" square head hood insulation retainer is just what your classic vehicle needs to keep your original hood insulation where it belongs...attached to the hood. This retainer is a service replacement for...


Product#: CM3004

1968-72 Outer Door Mirror; Chrome: LH; Smooth Style Base; Various GM Models

Reproduction of the original outer door mirror designed for use on various 1968-72 GM models. Each mirror is manufactured in quality die-cast zinc replicating the original mirror in quality and fit. This reproduction mirror...


Product#: 9785616

1955-82 Spare Tire Hold Down Nut; 5/16"-18 Thread; 3.88" Wide; Zinc Finish

OER® reproduction wing nut for many GM models. This spare tire hold down nut is used in conjunction with the spare tire hold down rod. Manufactured in stamped steel and features correct threads and wing nut design....


Product#: 10362

Bolt, 5/16-18 x 13/16" Pointed Tip With Hex Washer Head, Black Phosphate

OER® Authorized reproduction of the original hex head bolt for various GM models. This bolt was used for the installation of a number of parts on the front end of various GM models. Note: For a money saving set of 10 use...


Product#: 3899508

1959-80 Trico Windshield Wiper Blade; 15" Length; Various Models; Each

Reproduction 15 inch "TRICO Style # PR-15-2W" wiper blade for a wide variety of classic vehicle models. Each blade features stainless steel construction and is loaded with a period-correct TRICO RF-15 style insert with a...


Product#: 344330

1968-79 Camaro, Impala, Nova, Omega, Apollo, Ventura; Rear License Plate Bracket; with Hinge; EDP Coated

Reproduction rear license plate bracket for various 1968-79 GM models including 1969-77 Camaro, 1968-71 Impala, 1968-79 Nova, Omega, Apollo, Ventura, and more. Manufactured in stamped steel to factory specifications for an...


Product#: K402

1969-81 GM; Door Hinge Repair Set ; Except with 15mm OD Bushings

Reproduction of the original door hinge components for use on various GM models. Repair the broken door hinges with this comprehensive repair set. Each repair kit includes 4 properly hardened shoulder pivot pins and 8...


Product#: K51020

1962-76 GM, Dodge, Plymouth; Various Models; Convertible Top Boot Storage Bag

Why leave your top boot in the trunk exposed when you can keep it safe and clean by safely storing it in this special top boot storage bag. The storage bag will help protect your vehicles top boot while being stored in the...


Product#: 1706370

1970-81 Camaro, Firebird, Impala; Upper Front Door Hinge; Passenger Side; Various Models

This OER® reproduction door hinge will allow your door to work properly again! The 1970-81 doors were extremely heavy and hard on the original hinges. A new set of hinges will help your doors to open and close the way the...


Product#: 11503957

U-Nut; M6 - 1.0; Panel Range.030" to.160"; Center of Hole to Edge: 17/32"; Black Phosphate; Each

Black phosphate metric u-nut or foldover nut, that measures M6-1.0 to install and secure various components. Fits panel thickness from.80mm to 4 mm. (.030" to.160") Specifications: OE #: 11503957 Quantity: Individual Clip...


1971-76 GM B, C-Body; Front Windshield Glass; 2 & 4 Door; Hardtop, Sedan, Station Wagon; w/o Built-In Antenna; with Mirror Bracket; Clear
NEW

Product#: DW784C

1971-76 GM B, C-Body; Front Windshield Glass; 2 & 4 Door; Hardtop, Sedan, Station Wagon; w/o Built-In Antenna; with Mirror Bracket; Clear

OER reproduction front windshield glass for use with various 1971-76 Buick, Chevrolet, Pontiac, and Oldsmobile B and C Body 2 & 4 door, hardtop, sedan, and station wagon models without a built in antenna. This windshield is...


Product#: A1017

3/8"-16 x 15/16" Bumper Bolt With Flat; Zinc Plated Shank; Stainless Steel Flat Head; Each

Correct replacement style bolt to replace the original missing or damaged bumper bolt. Each bolt is manufactured to original specifications and will match the original. Fits a variety of different years and models. Measures...


Product#: T70623

1947-79 GM; Various Models; Chrome Drop Mount Peep Mirror; LH Or RH; 4"

OER® Authorized reproduction drop head mirror for 1941-79 GM model cars and trucks. Early style drop head mirror mount to top edge of door frame. Features a chrome arm with a 4 inch mirror head. Fits sedan and truck...


Product#: WB125

1955-72 Buick, Chevrolet, Oldsmobile, Pontiac; Kleerview Glass Washer Fluid Bottle; with Cap, and Mounting Bracket

Correctly reproduced glass windshield washer bottle that was common in various 1955-72 General Motors vehicles. Each bottle is manufactured in the correct factory configuration that replaces the old or missing original...


Product#: 999680

1956-82 Chevrolet; Buick; Oldsmobile; Pontiac; Cadillac; Power Window Motor; Includes Gear and Pigtail; New; LH/RH

New power window motor for various GM passenger car and truck models. Manufactured to factory specifications for an original fit and function. This original style power window motor was used in wide variety of GM models....