1973 Pontiac Ventura Parts - Axle Shafts & Parts

Original replacement locks for applications below. Fits 1967-81 with .150 horseshoe.

Prevent costly damage by replacing rear axle bearings before they seize with this premium replacement rear axle bearing. Always check the bearings and seals whenever removing the rear drums/axle for signs of wear. Sold...

Classic Industries® offers this sealed repair bearing that will replace the rear axle bearing on your classic when damage has occurred to the axle shaft from a worn-out bearing. This bearing is a sealed, self-contained,...

Prevent premature bearing or brake failure! Replace cracked or deteriorated rear axle seals to keep gear oil and grease in the axle tube, where it belongs. Sold individually. 2 required per vehicle. Applications: 1967-86...

Our improved C-Clip Eliminators eliminates the factory C-clip axle retention and provides a safety hub with sealed, press-on bearings. Now with an extra internal seal to help prevent leakage. The C-Clip Eliminators are...

Our improved C-Clip Eliminators eliminates the factory C-clip axle retention and provides a safety hub with sealed, press-on bearings. Now with an extra internal seal to help prevent leakage. The C-Clip Eliminators are...

Reproduction of the original rear axle compression bumper which attaches to the body and keeps the rear axle from bottoming out. Manufactured using hard rubber material with molded in stud for mounting. This is the second...

Moser offers forged steel street axles for 10 Bolt Chevrolet rear ends. These axles are non-tapered, with hardened bearing seats and machined C-clip grooves to fit OE applications. Sold as a pair. Made in USA Note: No...

Moser offers forged steel street axles for 10 Bolt Chevrolet rear ends. These axles are non-tapered, with hardened bearing seats and machined C-clip grooves to fit OE applications. Sold as a pair. Made in USA Note: No...

Moser offers forged steel street axles for 12 Bolt Chevrolet rear ends. These axles are non-tapered, with hardened bearing seats and machined C-clip grooves to fit OE applications. Sold as a pair. Made in USA Note: No...

Original GM rear axle bearing for use with 10 bolt rear ends. Always check the bearings whenever removing the axles. Applications: 1967-86 Camaro all 1967-86 Firebird all 1965 Impala / full size 10 bolt 1977-81 Impala /...

OER® reproduction of the ventilator used by GM on a multitude of applications from the 1950s thru todays cars and trucks including the rear axle housing, automatic transmissions. front transfer case on 4 x 4 models and...

Get better traction and prevent bottoming out with this adjustable pin pinion snubber for Chrysler 8-3/4 in. rear ends. When under heavy load (acceleration) the rear springs will compress, and the axle can rotate. A pinion...

Get better traction and prevent bottoming out with this adjustable pin pinion snubber for Chrysler 8-3/4 in. rear ends. When under heavy load (acceleration) the rear springs will compress, and the axle can rotate. A pinion...