1959-64 Chevrolet 4 Wheel Power Disc Brake Conversion Set with 11" Drilled/Slotted Rotors

Looking to convert your classic Chevrolet to 4-wheel disc brakes? Then this conversion set is the answer.

• 9"Power booster
• Master cylinder
• Proportioning valve and mounting bracket
• Stee l lines between master and valve
• 11" drilled/slotted front rotors
• Single piston black powder coated cast iron calipers
• Organic disc pads
• Caliper mounting brackets
• Braided stainless flex hoses and clips
• Bearingsand seals
• Spindle nuts, washers, cotter pins and dust caps
• 11" drilled/slotted rear rotors
• Loaded rear calipers with parking brake
• Rear parking brake cables
• Brackets and spacers to mount the calipers
• Flex hoses
• Mounting hardware

Mounts to stock front drum brake spindles. For use with non c-clip axles with a 3.375" flange. Requires minimum of 15" wheel.

• 1959 - 1964 Chevrolet Impala

• 1959 - 1960 Chevrolet El Camino

Photo for illustration purposesonly, set contents may vary. Additional parts may be needed for installation.

Important: Not for use with aftermarket drop spindles.

Note: Shipped overweight.